Airelec Agate Посібник із швидкого старту - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Обігрівач Airelec Agate. Airelec Agate 2 сторінки. Bathroom heater
Connection
Use of the model with switch
Pull the cord downwards to start the heater (with the previously selected wattage (1000W /2000W). Pull the
cord again to stop the heater.
Use of the model with timer
Pull the cord to start the heater with the previously selected power (1000W or 2000W). The heater
automatically begins to operate for a period of approximately 15 minutes.
Safety
•
Do not cover the heater or block the intake grids or air outlet.
•
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
c
concerning use of the appliance by a person responsible for their safety.
n
•
To maintain the performance of the heater, it is necessary to regularly remove dust from the interior by using
a vacuum cleaner on the inlet and air outlet.
a
•
Children should be supervised to ensure that they do not play with the appliance.
•
Use a soft cloth to remove the dust. To remove a stain, moisten the cloth.
•
Never use abrasives as they might damage the Polyester coating of the heater.
•
The device is protected by a thermal safety switch. If the unit overheats, the switch turns the unit off.
•
To reset – turn the function switch to the position 0 and wait for 5 minutes.
•
For the heater with timer – wait for the timer to stop completely.
Check that the air intake grids(rear panel) or air outlet(front) are not obstructed or blocked – clean them if
•
necessary.
i
•
Restart the device. If the fault persists – contact a registered electrician.
Caution: In order to avoid a hazard due to inadvertently resetting the thermal cut-out, this appliance must not be
supplied through an external switching device, such as a timer or connected to a circuit that is regularly switched
on and off by the utility.
Product Warranty – 10 year warranty
Any bathroom heater that is found to be defective due to substandard materials and/or workmanship within
10 (ten) years from the date of purchase, will be replaced. To make a claim under this warranty, contact the
store where you purchased your product.
Your claim will be assessed based on the information you provide. You will be required to return the defective
product for assessment at your cost. The warranty does not cover any installation or removal costs. The benefits
given by this warranty are additional to other rights and remedies that you may have under laws relating to our
products.
Our goods come with guarantees that cannot be excluded under the New Zealand/Australian Consumer Law. You
are entitled to a replacement or refund for a major failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of
acceptable quality and the failure does not amount to a major failure.
• The warranty does not extend to any consequential loss, damage, misuse, neglect, alteration or incorrect
installation.
• Items that have been cleaned with anything other than a stainless steel cleaner, will not be replaced.
• Attach your proof of purchase and keep it in a safe place with this warranty form. You must have your proof of
purchase for your warranty to be valid.
PHONE
0800 805 558
EMAIL
WEBSITE
www.tbw.co.nz