Dea OLI/N Series Інструкції з експлуатації та попередження - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкції з експлуатації та попередження для Відкривач воріт Dea OLI/N Series. Dea OLI/N Series 20 сторінок. Hydraulic operator for swing gates
Друкувати сторінку
2 PRODUCT DESCRIPTION
Models and contents of the package
OLI 600 identifi es a series of hydraulic gate operators with different features in terms of dimension (stroke), speed, reversibility, and
blocks.
OLI is a hydraulic operator for civil and industrial swing gates. It consists of a pump in an oil bath, powered by a single-phase electric
motor that drives a cylinder.
OLI 600 is completed by a set of accessories listed in the "PRODUCT ACCESSORIES" table (page 55).
Inspect the "Contents of the Package" (Pic. 1) and compare it with your product for useful consultation during assembly.
Transport
OLI is always delivered packed in boxes that provide adequate protection to the product, however, pay attention to all information that
may be provided on the same box for storage and handling.
3 TECHNICAL DATA
Motor power supply voltage (V)
Absorbed power (W)
Thrust force (N)
Traction force (N)
Duty cycle (cycles/hour)
Maximum n° of operations in 24 hour
Built-in capacitor (μF)
Operating temperature range (°C)
Motor thermal protection (°C)
Opening time 90° (s)
Weight of product with package (kg)
Sound pressure emitted (dBA)
Type of oil used
Protection degree
4 INSTALLATION AND ASSEMBLY
4.1 For a satisfactory installation of the product is important to:
• Verify that the gate complies with the legal requirements and then defi ne the complete project of the installation;
• Verify that the gate is well balanced and that it has no points of friction in opening and closing;
• Identify an area that allows a smooth and safe manual operation of the operator;
• Verify that the operator bulk (Pic. 2) is compatible with the area chosen for the fi tting (Pic. 3);
• Use the length/weight graphic and the provided installations dimensions evaluating whether you prefer a 90° or higher opening (Pic.
4).
4.2 Defi ned and satisfi ed these prerequisites, proceed to the assembly:
• Fix the rear junction to the pillar bu welding (Pic. 5);
• Fix the front junction to the gate by welding (Pic. 6);
• Keeping the motor in a horizontal position, mount it fi rst to the front bracket, then to the rear bracket (Pic. 7) ensuring that installation
dimensions shown in Picture 4 are respected.
• To prevent excessive pressure from forming inside the hydraulic cylinder, before carrying out opening/closing manoeuvres,
open the protective cover of the release system and loosen the screw on the handle by 1 turn (Pic. 8).
WARNING In order to make the structure suffi ciently strong, reinforcement plates to be fi xed to attachments may be necessary.
WARNING Grease pins before assembly.
602N (602AN) -
605N - 606N
603N - 604N
(607AN)
230 V ~ ±10% (50/60 Hz)
3980
3200
60
480
21
31
11,4
13
602LN (602LAN) -
603LN - 604LN
170
5600
4460
50
400
8
-20÷50 °C
130
30
11,4
< 70
AGIP Arnica A15
IP55
605LN - 606LN
(607LAN)
40
320
40
13
9