Adesys SVL Series Посібник - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник для Блок управління Adesys SVL Series. Adesys SVL Series 14 сторінок.

Adesys B.V. | Wateringen

Connection

To connect the SVL correctly, we recommend using exclusively Camden CTB922HE/# type connectors.

Measurements may be affected if other connectors are used.

2.1

Position the SVL where it is not affected by direct sunlight or other heat sources. Choose the place of

installation such that moisture cannot penetrate the device. The SVL can be mounted onto the TS35 rail

without screws. The permitted ambient temperature range for the electronics is -20°C to +55°C.

The transmission power of the SVL's internal GSM/4G module is higher than that of a standard mobile

phone. Under certain conditions this may affect the functioning of surrounding electronic equipment. The

effects depend upon the distance between the antenna and surrounding equipment.

2.2

Affixing and removal: DIN rail

The SVL should be affixed to a DIN rail before connection.

• Put the SVL onto the DIN rail at an angle [1]. It is important that the SVL's DIN rail clip is positioned on

the top of the DIN rail.

• Tilt the SVL to clip it into place [2]. Then check whether it is securely seated.

The SVL is removed from a DIN rail as follows.

• Place a screwdriver on the underside of the DIN rail clip [3]. Use this as a lever; after approx. 3 mm the

SVL can be tilted to release it from the DIN rail.

2.3

SIM card

If the SIM card has a PIN code, this should be entered in the setup tool SV-prog. The required SIM card is

installed as follows:

• Switch the SVL off by disconnecting the supply voltage, then press and hold the reset key for 8 seconds

to switch off the dialer;

• The SIM card holder is made accessible by pressing the button next to it using a sharp object. The

holder is then pushed outwards;

• Place the SIM card in the holder and slide this back into the SVL;

• Reconnect the supply voltage to switch the SVL on.

The SVL should be completely switched off before the SIM card is installed. Fitting or removing the SIM

card with the SVL switched on may damage the SIM card.

Manual SVL 4G Weblogger

Page 5