aireRyder F0028 Посібник - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник для Вентилятор aireRyder F0028. aireRyder F0028 10 сторінок. Original ceiling fan

Друкувати сторінку

Receiver

DIP Switch

Fig.9

Transmitter

Fig.10

Antenna

Fig.11

Antenna:

DO NOT CUT

OR SPLICE

Fig. 12

Hanger Bracket

Screw

Washer

Remove the 4 hanger bracket screws

and washers from the hanger bracket.

Attach the canopy to the hanger

bracket, then secure it with four

screws and washers.

There is a code switch in the transmitter

Antenna

and receiver. This "DIP Switch" is a 4 key

unit (Fig.9). All keys were set at "ON"

position in the beginning. Set the keys to

a different code. Make sure the same

numbered keys are switched "ON" for

both DIP Switches (Fig.9a). Take note

that the "ON" position may have different

orientation for each.

Receiver

Hanger Bracket

Receiver

Canopy

Move ground wires (a), outlet box wires (b), and

motor wires (c) away from the center of the hanger

bracket. Then slide receiver through hanger

bracket as shown, Antenna end first, until it is

centered. Finally, cut motor wires (c) to length

needed for connections.

Connect wires:

1) The white (neutral) wire from motor to the white (neutral)

"To Motor N" wire from Receiver with a wire nut.

2) The black (hot) wire from motor to the black (hot) "To

Motor L" wire from Receiver with a wire nut.

3) The blue wire from motor to the blue "For Light" wire

from Receiver with a wire nut.

4) The white (neutral) wire from Outlet Box to the red "AC

Hanger

in N" wire from Receiver with a wire nut.

Bracket

5) The black (hot) wire from Outlet Box to the red "AC in

L" wire from Receiver with a wire nut.

6) The ground wire from Outlet Box to the green ground

Hanger

wire from the Hanger Ball and the green ground wire

Ball

from the Hanger Bracket with a wire nut.

Make sure all of wire nuts are connected firmly.

*** Put all wire nuts and wires carefully up into the Outlet Box,

EXCEPT antenna, which should remain outside Outlet Box.

Safety Cable Hook

Safety

Cable

Hang the safety cable

into the safety cable hook.

PAGE: 6 / 9

Code example:

1-ON 2-OFF 3-ON 4-OFF

on both DIP Switches.

Fig.13

140819