DEAD FLY ZONE AMS-S1 Інструкція з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Приймач DEAD FLY ZONE AMS-S1. DEAD FLY ZONE AMS-S1 4 сторінки.

5) Turn the lid upright and place it on the drum so the In-Drum Assembly is inside the drum.

Connect the 3/8" intake tubing to the intake on the pump, inserting it until clicks (Fig. 1).

6) Connect the 12" long piece of 1/4" tubing to the needle valve and insert the opposite end

into the hole in the drum (Fig. 2).

7) Connect tubing that will go around your facility and connect to your spray nozzles to the

1/4" output (Fig. 3). Install your tubing, nozzles, and fittings by following the design we

did for you, if we did one. The design will show you where every single component of

your misting system is located in your facility. You will need to cut the tubing to the

correct lengths and push the tubing into the fittings and spray nozzles. You will feel a

"click" when the tubing is seated inside the fittings and spray nozzles correctly, and you

will not be able to pull it out without using the provided disconnect tool, which pushes the

collar inward and releases the "teeth" inside the fittings and spray nozzles.

8) Once you have all your tubing and nozzles in place, fill your reservoir about 50% with

water only.

9) Turn your "Misting Time" knob to its highest setting and then press the "Mist Now" button

on the front of your faceplate (see red arrow in image below). Let the pressure build and

adjust your PSI on your liquid filled pressure gauge to 190-195. Adjust this pressure

using the key seen in Fig. 4.

10) Once you have confirmed all nozzles are spraying and your PSI is adequate, pour your

insecticide into the reservoir and fill with water to roughly 6" from the top. Use a broom

handle to give it a quick stir. Now replace lid and secure with lid ring.