aireRyder FN66635 Інструкція з монтажу та використання - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з монтажу та використання для Вентилятор aireRyder FN66635. aireRyder FN66635 8 сторінок. Ceiling fan model borealis
Друкувати сторінку
Fig.1
Turn off the electric circuit at the
main fuse or circuit breaker box.
Fig.3
Remove the Hanger Ball screw, then
slide the Hanger Ball downwards.
Fig.6
Decorative Cap
Downrod Stand
Cover
Hanger Pin
Loosen the collar screws in part way.
Insert the Downrod into the Collar.
Slide Hanger Pin through holes of
Collar and Downrod.
F A N
C O
171213
Hange r
Bracket
Flat Washer
Spring Washer
Fig.2
Fig.4
Hanger Pin
Slide the support pin out. Remove the
Ground Wire screw. Remove the
Lock Pin and take off the Hanger Pin.
Remove the Hanger Ball.
Fig.7
Fig.7
Downrod
Canopy
Collar Screws
Collar
Insert and tighten the two Collar
Screws. Slide Lock Pin into Hanger
Pin until it is locked into position.
Attach the hanger bracket to the ceiling
with spring washers, flat washers and 2
mounting screws.
Note: For sloped ceiling installation, make
sure that the hanger bracket is installed so
that the guide pin is facing upward.
Guide Pin
Support Pin
Ball Joint
Screw
Lock Pin
Lock Pin
Fig.5
Decorative Cap
Motor Wires
Cover
Collar
Thread the motor wires through the
downrod stand cover, decorative
cap, canopy and downrod.
Fig.8
Hanger Bracket
Slot
Chip
Hang the fan on Hanger Bracket, and
make sure the slot of hanger ball is
snapped into the chip of Hanger
Bracket exactly.
Note: For slope ceiling installation,
make sure the slot of hanger ball and
the chip of hanger bracket face down.
Downrod
Canopy
Downrod Stand
3