aireRyder FN73335 Інструкція з монтажу та використання - Сторінка 15

Переглянути онлайн або завантажити pdf Інструкція з монтажу та використання для Вентилятор aireRyder FN73335. aireRyder FN73335 19 сторінок.

aireRyder FN73335 Інструкція з монтажу та використання
1. Pass the supply wires through
the hole in the mounting bracket.
Secure the mounting bracket to a
ceiling joist or other structural
ceiling element with two screws,
spring washers and flat washers.
Ensure that the support for the
mounting bracket is capable of
safely holding the moving weight
of the fan.
Blue
Brown
Green/Yellow
Terminal block on
From House
Mounting bracket
4. Make wire connections. Follow diagram above and make sure that all exposed wires are tightened by
the screws on the terminal block.
Note: Wires from house may vary in color and may not include ground wire (green/yellow). After wiring is
completed, gently push wires into junction box with terminal block upward (if applicable).
5-1. After the splicing has been made, gently
place the receiver into the canopy and secure it
in place using double-sided adhesive tapes
which pre-adhered on the back of the receiver.
5-2. Take off side screws (one of each across)
on mounting bracket first, then loosen the other
two.
2. Lift the fan assembly and
hand onto the hook on mounting
bracket. This will permit you to
make the electrical connections
without having to hold the fan up
as well.
Blue
Brown
Green/Yellow
From mounting bracket
6-1. Push up the canopy until the two screws on
mounting bracket are engaged with L type slot holes
on canopy.
6-2. Rotate the canopy slightly until the two screw
heads are in the L type slot holes.
6-3. Tighten 4 screws firmly.
3. There is a frequency-setter in
both the transmitter and receiver.
This "DIP Switch" is a 4-key unit.
All keys were set to "ON" position
initially. Set the keys to a different
code.
Make
sure
numbered keys are switched to
"ON" for both DIP Switches.
Please note that the "ON" position
may have a different orientation in
each device.
Blue
Blue (Motor-N)
Brown
Brown (Motor-L)
Orange
Orange(For light kit)
the
same
From Fan
3