Gamber Johnson Tab Cruzer 7160-0581 Інструкція з монтажу Посібник з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Док-станція Gamber Johnson Tab Cruzer 7160-0581. Gamber Johnson Tab Cruzer 7160-0581 6 сторінок. Samsung galaxy tab active docking station
Друкувати сторінку
WIRING INSTRUCTIONS
IMPORTANT: Make sure that you have read this entire section before you begin
wiring! Refer to Figure 1.
1. Install docking station into vehicle, making sure that all bolts are tight.
2. Connect BLACK ground wire to the location where the vehicle battery grounds
to vehicle chassis. Use a minimum of 16 AWG wire.
3. Connect RED power wire to the supply voltage (Battery, V+)through fuse from
the vehicle.
IMPORTANT REMINDERS:
•
Use only SAE J1128 Type GPT number 16 AWG stranded wire (minimum) to
attach the docking station to the vehicle's electrical system.
•
Connect lead wires using appropriate wire connecting devices. Examples
would be: Butt Splices, Quick Dissconects or Terminal Blocks.
•
Use Proper Crimp tools to make sure that correct crimp is applied properly to
avoid wire from becoming disconnected and making sure good
connection.
•
Route the lead wires to the battery. Total wire in the circuit must not exceed
30 feet and must conform to SAE standard J1128.
•
Protect the lead wires from abrasion and chafing by using wire loom or
conduit, and route away from moving parts or areas where high
temperatures may occur.
•
The power connection must be made with a 5 amp in-line fuse.
•
The fuse holder location must be kept within 10 inches of the connection to
the battery positive, away from moving parts, and temperatures that
exceed 180 degrees F.
•
Caution: For continued protection against risk of fire replace only with the
same type and rating of fuse.
•
If a timing device is used follow the instructions of the manufacturer of that
device. It must be wired in-line with the supply voltage (V+) to the docking
station.
•
If you have any installation questions, please call Gamber-Johnson customer
support at 1-800-456-6868
Figure 1
Ground to Vehicle Chassis
16 AWG (black wire) J1128 Type GPT
-
+
Vehicle Battery
Fuse Holder
16 AWG (red wire) J1128 Type GPT
5 Amp Fuse
Connect to
Dock GND
Connect to
Dock PWR