Deaf Bonce Machete series Посібник користувача - Сторінка 5

M I X E D C O N N E C T I O N O F T H E S P E A K E R S

S E L E C T I O N O F T H E D I A M E T E R O F S P E A K E R C A B L E S

Use the table below to select the desired diameter based on the length and the power consumption.

4 . F I L T E R I N G , R E C O M M E N D E D A M P L I F I E R S E T T I N G S .

The correct choice of amplifier settings, filtering and enclosure largely influence on the lifespan of your audio

system. You should select an amplifier with a nominal power, not exceeding the nominal power of the speakers.

Proper coordination of the head unit (HU) of the amplifier will allow to get a clean, undistorted signal applied to

the component to prevent overheating and voice coil damage. The recommended HU volume is not more than

80%, input sensitivity of the amplifier is 50%.

The recommended filter settings:

The high pass filter HPF (a Filter that cuts off all frequencies below the frequency setting of the filter)

is about 200-250 Hz (24 dB/Oct), or 300-350 Hz (12 dB/Oct)

The low pass filter LPF (a Filter that cuts off all frequencies above the frequency of the filter) - 6-8

kHz (12 dB/Oct).

Recommended amplifiers: AAK-OGO2500.1D, AAK-OGO1500.2D, AAK-180.4, AAK-200.4D, MFC-

120.2, MFC-90.4, MA-150.4, MA-130.4, MA-80.4, MA-50.4.

CAUTION!!! High sound pressure can damage your health!

Please use the common sense when controlling volume!

Voice coil

4 Ohm

Total impedance

4 Ohm