Airespace AS 1500 Посібник зі швидкого встановлення - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник зі швидкого встановлення для Бездротова точка доступу Airespace AS 1500. Airespace AS 1500 15 сторінок. Intelligent rf ap

Друкувати сторінку

Step 2: Configuring the Airespace AP Before Installation

The following procedures are designed to make sure that your Airespace AP physical installation goes

smoothly and that initial operation is as expected. If you are unable to prepare your Airespace AP for

deployment, this Step also describes RMA (Return Material Authorization) procedures.

Perform the following procedure on each Airespace AP BEFORE deploying the

Note:

Airespace AP in its final location.

Configuration Setup

Configuration Steps for an Airespace AP

Configure the Airespace Switch or Appliance for LWAPP Layer 2 Mode (use the CLI command

show switchconfig to determine the mode; if it is set to layer 3, use the CLI command config

switchconfig mode L2 to change it to Layer 2). Make sure the Airespace Switch or Appliance DS

Port is connected to the network. Use CLI, Web Browser and/or ACS procedures as described in

the

Airespace Switch and Appliance Quick Installation

Quick Install Guide and the

Make sure AP ports are available (either Direct-Connect Mode through the Switch

physical ports, or in Appliance Mode through the Airespace Switch or Appliance

Management/AP-Manager Interface).

Set the Airespace Switch or Appliance as the Master, so new Airespace APs always

associate with it. Use the CLI command show network config to determine if the

Airespace Switch or Appliance DS Port is the Master. If it is not, make it the Master with

the CLI command config network master-base enable. Make sure to use the CLI

command config network master-base disable after you have configured the AP(s).

Refer to the

Take the Airespace AP out of the box and plug it into a front-panel 10Base-T connector on the

Master Switch (Direct-Connect Mode), or through the same subnet that Airespace Switch or

Appliance is on (Appliance Mode).

Apply power to the AP:

Use 802.3af-compatible Power Over Ethernet (PoE) from the Airespace Switch or

Appliance or from an orderable inline power injector. If you do not have PoE available,

use an orderable external AC-to-48 VDC Power Supply plugged into the side of the AP.

After powering up the AP, the RED Alarm LED comes on for a short period (about 15-20

seconds) and then all the LEDs blink sequentially back and forth, indicating that the AP

is trying to connect to an Airespace Switch or Appliance. This can continue for up to five

12/29/04

90-100tbd-000 Rev 1 (Preliminary 3)

Configuration Steps for an Airespace AP

Airespace Product

Airespace Product Guide

Step 2: Configuring the Airespace AP Before Installation

GuideAirespace Switch and Appliance

GuideAirespace Product Guide.

for other settings.

Step 2: Configuring the Airespace AP Before Installation