HIKOKI DH14DSL Інструкція з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Перфоратор HIKOKI DH14DSL. HIKOKI DH14DSL 16 сторінок. Cordless rotary hammer
Друкувати сторінку
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
DH14DSL / DH18DSL:
Cordless Rotary Hammer
Read all safety warnings and all instructions.
V
Rated voltage
n
No-load speed
0
Pm
Power mode
Sm
Save mode
Concrete
Steel
Wood
Rotation only function
Rotation and hammering function
Switching ON
Switching OFF
Disconnect the battery
SPECIFICATIONS
Model
Voltage
No-Load Speed (Save/Power)
Full-load impact rate (Save/Power)
Capacity
Drilling
Weight
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect to the power source. (Fig. 2)
When charging the battery from an AC power source
○ Connect the charger's power cord to the receptacle.
<UC18YFSL, UC18YML2>
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1-second intervals).
<UC18YSL3>
When connecting the plug of the charger to a receptacle,
the charge indicator lamp will blink in red (At 1-second
intervals).
Concrete
Steel
Wood
5
Light switch
Remaining battery indicator switch
Clockwise rotation
Counterclockwise rotation
The battery remaining power is nearly empty.
Recharge the battery soonest possible
The battery remaining power is a half.
The battery remaining power is enough.
Prohibited action
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains the
accessories listed in Table 3 on page 9.
Standard accessories are subject to change without notice.
APPLICATIONS
Rotation and hammering function
○ Drilling anchor holes
○ Drilling holes in concrete
○ Drilling holes in tile
Rotation only function
○ Drilling in steel or wood
(with optional accessories)
○ Tightening machine screws, wood screws
(with optional accessories)
DH14DSL
14.4 V
0 – 750 /min / 0 – 1500 /min
0 – 3100 /min / 0 – 6200 /min
16 mm
13 mm
18 mm
2.1 kg
CAUTION
Do not use the electrical cord if damaged. Have it
repaired immediately.
When charging the battery from a DC 12V in-car power
source (UC18YML2)
○ Secure the battery charger in place in the car.
Use the strap supplied with the battery charger to fasten
the battery charger in place and prevent it from moving
inadvertently. (See Fig. 17)
CAUTION
Do not place the battery charger or battery under the
driver's seat. Secure the battery charger in place to
prevent it from moving inadvertently as this may lead to
an accident.
DH18DSL
18 V
2.2 kg