Airetool FPT-9800-7-GM-150 Посібник з експлуатації та обслуговування - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з експлуатації та обслуговування для Цвяходер. Airetool FPT-9800-7-GM-150. Airetool FPT-9800-7-GM-150 16 сторінок. Fpt-9800 series. freeze plug removal tool

Друкувати сторінку

Safety Recommendations

For your safety and the safety of others, read and under-

stand the safety recommendations and operating instruc-

tions before operating this tool.

ALWAYS WEAR PROTECTIVE EQUIP-

MENT

EYE AND FACE PROTECTION

For additional information on eye and face protection, refer

to Federal OSHA Regulations, 29 Code of Federal Regula-

tions, Section 1910.133., Eye and Face Protection, and

American National Standards Institute, ANSI A87.1, Oc-

cupational and Educational Eye and Face Protection. Z87.1

is available from the American National Standards Insti-

tute, Inc., 1430 Broadway, New York, NY 10018.

HEARING PROTECTION

Hearing protectors are required in high noise areas, 85

dBA or greater. The operation of other tools and equipment

in the area, reflective surfaces, process noises and reso-

nant structures can substantially contribute to, and increase

the noise level in the area. For additional information on

hearing protection, refer to Federal OSHA Regulations, 29

Code of Federal Regulations Section 1910.95, Occupa-

tional Noise Exposure, and American National Standard

Institute, ANSI S12.6 Hearing Protectors.

Page 2

Follow good machine shop practices. Rotating shafts and

moving components can entangle and enwrap, and can

result in serious injuries. Never wear long hair, loose fitting

clothes, gloves, ties or jewelry when working with or near

any power tool with an exposed rotating shaft or spindle.

When using right angle Airetrols with lever type throttles,

be sure the throttle is positioned relative to the angle head

so that the throttle will not become wedged against an

adjacent object in the "ON" position due to the torque reac-

tion. The angle head may be repositioned with the respect

to the lever to accommodate proper location foe the task. If

tool is to be reversed, locate the throttle lever in a neutral

position that will prevent entrapment. Refer to operating

instructions for additional information.

Tools with clutches can stall rather than shut-off if ad-

justed over the maximum power output of the tool, or if

there is a drop in air pressure. Operator must then resist

the stall torque until the throttle is released.

Higher torqueAiretrols, inline and right angleare supplied

with a torque reaction bar designed to work with the torque

of the tool it is for, be equipped with splined torque reac-

tion mounting plates which accept torque reaction bars.

These bars can be braced against the work or other suit-

able points to absorb and relieve the operator of the torque

reaction transmitted by the tool. Tool balance arms are

also available to absprb the torque reaction of the tool while

balancing the weight of the tool for improved ergonomic

applications.

Some individuals are susceptible to disorders of the hands

and arms when exposed to tasks which involve highly