GameChanger plus pedal Посібник користувача - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник користувача для Музична педаль GameChanger plus pedal. GameChanger plus pedal 8 сторінок. Sustain unit for all melodic instruments
Друкувати сторінку
TECHNICAL SPECIFICATIONS
INPUTS:
IN
Input Type
Input Impedance
Max Input Level
OUTPUTS:
OUT
Output Type
Output Impedance
Max Output Level
Max ADC input
Max DAC output
Sample Rate
A/D D/A Conversion
Frequency Response
Analog/Digital
Signal to Noise Ra�o
THD
Controls
Indicator
Connectors
Power Consump�on
Power Requirements
PLUS PEDAL Dimensions (WxDxH) 90 x 195 x 72 mm (3.55 x 7.7 x 2.8 in)
PLUS PEDAL Weight
Footswitch Dimensions (WxDxH)
Footswitch weight
RETURN
1/4" Unbalanced TS
1MΩ
+6.8dBu
CLEAN OUT
SEND
1/4" Unbalanced TS
100Ω
+6.8dBu
-1.8dBu
+5.2dBu
26kHz
16 bit
20Hz to 22kHz/13kHz
-97 dB (A weighted); ref = max level,
22 kHz bandwidth
-84 dB, ref= 6dBu, 1kHz
2-posi�on foot pedal, Poten�ometers:
BLEND, SUSTAIN, RISE, TAIL, Switches:
GROUP/SINGLE, SPLIT/MIX, addi�onal
footswitch input.
3-level check and pedal state indicator
IN, CLEAN OUT/FSW, OUT, SEND,
RETURN
1.8W
200mA, 9VDC, center nega�ve 2.1 x
5.5 mm plug.
1020 g (2.25 lbs)
58 x 66 x 46 mm (2.3 x 2.6 x 1.8 in)
230 g (0.5 lbs)
REFUND AND WARRANTY:
15
You have a 30 day return period when you may return the product and receive a
full refund. You will only be responsible for return shipping charges.
Each PLUS Pedal manufactured by Gamechanger Audio (PLUS Pedal Ltd) is warrantied to be free
from defects in materials and workmanship for one year from the date of shipping, or longer if
required by the relevant legislation.
This warranty shall not apply to any PLUS Pedal unit which in the opinion of the manufacturer has
been used improperly, or has been mechanically or otherwise damaged by accident, misuse or
negligence or has been altered or repaired in such a way to impair performance, nor shall it apply
to cosmetic defects, considered normal wear and tear.
Other parts which may have a limited life-span due to degradation as a function of use, such as
knobs, rubbers, audio cable connectors, are non-replaceable. The manufacturer reserves the
right to make changes in design or construction of this equipment without obligation to install
similar changes in equipment already sold.
WARNING:
Use only power supplies that can produce at least 200mA of current at 9V DC (center negative 5.5 x
2.1mm barrel connector).
This device may be subject to signal interference when operating near high power mangetic field
generators, especially when using extended length audio cables, and this is considered normal operation.
FOR THE US:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Unauthorized changes or modification to this system can void the users authority to operate this equipment.
This equipment requires shielded interface cables in order to meet FCC class B Limit.
For Europe:
This product complies with the requirements of Electromagnetic Compability Directive 2014/30/EU
For Canada:
NOTICE: This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
AVIS: Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel
brouilleur du Canada.
PLUS Pedal is an audio electronics product developed by
Gamechanger Audio (PLUS Pedal Ltd.)
www.pluspedal.com
Tomsona Street 33a/32
LV-1013, Riga, Latvia;
+12024079741
+37128377919
16