Gree GDN50BA-A3EBA2D Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Осушувач повітря Gree GDN50BA-A3EBA2D. Gree GDN50BA-A3EBA2D 18 сторінок.

Gree GDN50BA-A3EBA2D Посібник користувача
NOTES :
▪ The drain bucket must be correctly locked into place for the dehumidifier to work.
▪ Do not remove the drain bucket while the unit is running.
▪ Each time you press a button on the control panel, the appliance emits a beep.

4.2. BUTTON FUNCTIONS

POWER ON / OFF
Press this button to turn the dehumidifier ON or OFF. When turned on, the power indicator
on the control panel will light up and the dehumidifier will emit a beep.
INCREASE / DECREASE
Press these keys to adjust the desired humidity level between 35 and 80 %. Each press of
the "+" or "−" button increases or decreases the humidity level by 5 %.
AND / OR
To set the unit to Nonstop mode, use the "−" button and decrease the humidity level under
35 %. In this mode, the unit will operate continuously using its maximum dehumidification
settings stopping only when the drain bucket reaches full capacity (unless a drain hose has
been connected to the unit).
Tip : When first using the dehumidifier, set the humidity level to 45 % or 50 %. Allow 
at least 24 hours for the dehumidifier to achieve the humidity level. If after that time 
the air is still damper than desired, set the humidity level to a lower setting or select 
Nonstop mode for maximum dehumidification.
FAN SPEED SELECTION
Press this button to set the fan speed of the dehumidifier to your desired comfort level.
Speeds include : High, Medium and Low. The corresponding indicator will light up for each
speed.
SET TIMER
To set a Switch-Off Timer, press this button while the unit is running. To set a Switch-On
Timer, press this button while the unit is turned off.
Press once to set a time value of 2 hours. Press again to set a time value of 4 hours. The
corresponding indicator will light up on the control panel. Pressing a third time will reset the
time value to zero and the time indicators will turn off.
FILTER REMINDER RESET
After 250 hours of operation, the Filter indicator will light up to remind you to clean the
filter. After having cleaned it, press this button to turn off the Filter indicator and reset the
operating hours to zero.
PUMP FUNCTION (models with integrated water pump only)
Hold down this button for 3 seconds to activate the water pump function. The Pump mode
indicator will light up. When the drain bucket becomes full, the pump will automatically start
draining the water away.
Note : A drain hose must be connected to the pump port for this mode.
4. OPERATION GUIDE
9