Airfield Audio LIMINATOR Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Обладнання для запису Airfield Audio LIMINATOR. Airfield Audio LIMINATOR 9 сторінок. Class a dual transformer compressor

Друкувати сторінку

1. IMPORTANT : SET THE MAINS SWITCH ON THE REAR PANEL TO THE

CORRECT VOLTAGE.

2. Be certain that the unit has a ½ AMP fuse (115 VAC mains)

or ¼ AMP fuse (230 VAC mains).

3. Connect a line level audio input cable from your source (microphone preamp, EQ,

guitar or bass preamp / effects box, analog console or analog output from your

DAW) to the 3 pin XLR / ¼" female connector. The input connector is Balanced

Transformer Coupled, pin 2 hot.

4. Connect an audio output cable to the 3 pin XLR male connector and plug it into

the input of your recording or mixing device. The output XLR is Balanced

Transformer Coupled, pin 2 hot.

5. Connect the supplied IEC power cable to the IEC mains socket on the rear panel.

USE ONLY A 3 PRONG GROUNDED POWER CABLE. For safety reasons do

not lift the ground on the power plug by using a 3 to 2 ground lift adapter.

6. Link Jack: connect a standard ¼" unbalanced guitar type cable between 2

Liminator units for stereo operation. Y-cables should be used in a daisy-chain

configuration for multi-channel operation of 3 or more Liminator channels.

7. Turn on the unit and allow 30 minutes warm up.

INSTALLATION

REAR PANEL VIEW

- 3 -