Centre Point 400110 Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Лазерний рівень Centre Point 400110. Centre Point 400110 17 сторінок. Multi-line laser level
Друкувати сторінкуUsing the Laser (continued)
SETUP
Select a place as close as practical
•
to the work site. Ensure the location
is clear of traffic.
Place the laser on a level surface
•
such as a bench or supplied mount.
OPERATION
Powering on (self-levelling)
To turn the instrument on, slide the power
•
/ locking switch to the "unlocked" position
(Fig.4). Self levelling will commence and the
horizontal beam will activate (Fig.5).
Press the line mode button on the control
•
panel to cycle through the active beams (Fig.6).
If the instrument is outside the self levelling
•
range the instrument will not level causing the
laser beam to flash on and off repeatedly. If this
occurs, reposition the instrument onto a level
surface until the instrument can level off.
Powering off (self-levelling)
To turn the instrument off, slide the power
•
/ locking switch to the "locked" position.
Tilt lock function (manual mode)
Ensure the power / locking
•
switch is in the "locked" position.
Press and hold the line mode button for
•
3 seconds. The horizontal line will activate.
The instrument can now be
•
tilted to the desired angle.
Press the line mode button on the control
•
panel to cycle through the active beams.
To turn off the beams, press the line
•
mode button until all beams are off.
When in tilt lock function (manual mode)
the instrument will not self level and
correct for vibrations and/or disturbances.
Active laser beams will flash every four
seconds when in manual mode.
6
FIGURE 4
FIGURE 5
LINE
PULSE
FIGURE 6