Adexa ZBS Series Посібник з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Льодогенератор Adexa ZBS Series. Adexa ZBS Series 5 сторінок. Commercial flake ice maker

Друкувати сторінку

storage container, the ice full indicator on the display panel

will light on and the ice maker will stop automatically;

If there is a water shortage or something wrong with the water

supply system, the water shortage indicator will light on and the

ice maker will stop operation automatically.

6. For the ice

f laker

use purified water as water source, if the water

shortage indicator light and no ice is made when start the ice

f laker

procedure, maybe there is air in the water inlet tube. Unplug

one end connecting water inlet tube and water valve of ice

then open water inlet switch till there is water and air come from

another end. Then connect the water inlet tube with water valve of

ice

f laker

quickly.

MAINTENANCE:

1.If the compressor stops for any reasons like water shortage, too

much ice, power off, etc., Don't restart it right away. You can

restart it 5 minutes later to protect compressor.

2.Check regularly the connectors of the water inlet and outlet tubes

and drain the little surplus water that may occur.

3.If the ice

f laker

will be unused for long periods of time, please

screw off the plastic drainage connector screw on the back of the

ice

f laker

so as to drain the surplus water in the water groove. Then

screw it on. Wipe the inner liner of the ice storage container with a

clean rag.

4.When plugging or unplugging,

the plug should be held by hand

and the wires should not be

dragged heavily.

5.Please clean the ice

f laker

and its water supply system for one time

every month. The ice

f laker

should be unplugged before cleaning.

f laker

3.The ice

flaker

should be placed on

horizontal and structurally sound

ground and away from heat source

and corrosive gas.

At least about 150mm room

should be left around the ice

maker to ensure the fine ventilation.

4. Please adjust the feet when placing the ice maker some where,

otherwise the water level will be effected and so do the ice

shape.Before using the ice

f laker

wait about 12 hours after positioning it in a proper place.

5. The outlet of drainage tube should be lower than cabinet so as to

drain water easily.

6. Voltage range:

187V

187 ~ 242 V

7. The rated capacity of wire should be over 6A, the section area of

the wire is 0.75mm . The wire could be consisted by single ply or

multiplies. The rated current of fuse is 5A.

8.The grounding must be good.

＞150mm

for the first time, you should

220V

242V