Adexa CP-12S Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Духовка. Adexa CP-12S. Adexa CP-12S 14 сторінок. Electric conveyor pizza oven

Adexa CP-12S Посібник користувача
During operation, some parts of the appliance may be very hot. Try to avoid getting burnt
and never touch any hot parts without gloves on.
Warning!
This product is intended for commercial use only! It should be operated by
professional cook. No leaning is allowed when the unit is in use.
No modifications and dismantlement are allowed. Any modifications would lead to
product damage and property loss.
Cut power supply off when the unit stays idle. Do not open the housing of the unit.
Inside the unit, there is high-voltage circuit. It might be dangerous if dismantlement
occurs.
Do not place heavy objects on the unit. Do not touch the outside surface when it is
in use. Otherwise you may get burnt.
When lighting is approaching, shut off power supply. Do not touch the unit with objects with
sharp edges or points. Please check power cord periodically. If it is broken, please contact
the qualified technician for repair and replacement. There is danger potential if the power
cord does not reach the requirement of circuit.
Note that the power cord should never touch any heat sources or sharp edges.
Never let the power cord dangle over the counter edge.
Stop using the appliance immediately if malfunctions of the unit occurs. Shut
power supply off.
Do not use any accessory or spare parts that have not been recommended or
designated by the manufacturer. This can pose a danger for the user or lead to damages of
the appliance or personal injury.
Do not lay the power cord over carpets or heat insulations. Do not cover it
with any other objects. Keep away the power cord from operating range and do not immerse
it into water.
Never touch the power cord, plug or the switch when your hands are wet.
Do not leave the unit unattended during operation.
WARNING! Hazard via electrical current! Make sure that the voltage of local
power supply matches that of the naming plate.
5.2 Installation and connection
ATTENTION! The installation of the unit must be performed by a qualified technician
only. Place the device on top of a solid, even, safe and stable surface that tolerates the weight.
WARNING!
Danger of burning!
Warning!