Aguilar AG 500 Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Aguilar AG 500. Aguilar AG 500 7 сторінок. Aguilar ag 500 & gs 410
Також для Aguilar AG 500: Брошура та технічні характеристики (3 сторінок), Брошура та технічні характеристики (2 сторінок)
Друкувати сторінку
Pull Series
signal path.
When this knob is pushed in the Effects Loop is configured in
"parallel" and you can mix your "dry" signal with the signal from
the Effects Loop. When this knob is pulled out the Effects Loop is
configured in "series" and all of your signal will pass through the
Effects Loop. If you do not have anything plugged into the Effects
Loop pulling this knob will cut off your signal completely.
D.I. Section
D.I. Nominal Output Level: -20dBu
Pre/Post
D.I.
Lift/Ground
a ground loop. In many cases pushing in the
can fix this problem.
* Note: The AG 500 will not be harmed by phantom power
through the D.I. Phantom power is a power supply that can be
switched on at the channel input of some mixing consoles. It is
used to power some types of microphones. Use of phantom power
(usually labeled as 48V) will have no effect on the D.I. or the
amplifier in general.
B. Rear Panel Features
Speaker Outputs: Two Speakon outputs and two ¼" outputs are
provided. Any combination may be used as long as the load does not
exceed 4 ohms.
Tuner Output: One ¼" Tuner output is provided. When the amplifier is
muted your signal will still reach the tuner.
: Removes any "dry" (un-effected) signal from the
Button:
Pre
- Your signal goes to the D.I. XLR output jack before
Gain
Saturation
your
,
–10dB
input pad.
Post
Gain
Saturation
-
,
be sent to the D.I. XLR output jack. * Please note that
Post
when
is selected each
independently to balance channel levels. If one level is set
during sound check and the other is not you may not have
equal volumes when channel switching.
: If there is a hum when using the D.I. there may be
and EQ settings, but after the
Master
, EQ,
settings and effects will
Master
control must be adjusted
Lift/Ground
button
6.