decakila KMHS003W Посібник - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник для Машинка для стрижки волосся decakila KMHS003W. decakila KMHS003W 7 сторінок.
Також для decakila KMHS003W: Посібник (19 сторінок)
CUTTING LENGTH ADJUSTMENT
• To set the cut length, turn the cut length control wheel to set a shorter or longer cut. The
cutting length is marked on the side of the comb.
• Set the thinning control to the left for fine hair or to the right for cutting.
HAIRCUT
• Before starting, comb the hair in the direction of hair growth as shown. Turn the cutters on by
sliding the on / off switch to the "O" position.
• Pressing the Comb against the head, start by trimming the sides from the bottom of the head
up.
• Slowly move the clippers to the top of the head cutting small amounts at a time.
• Repeat step 6 around both sides and the back of the head.
• Clip the top of the head from front to back.
NOTE: Do not push the razor or force the razor through the hair.
WARNING: Mower blades are very sharp when not protected. CAUTION: Care must be taken when
using the clippers without the trim guide attached, as the clippers will remove any hair that comes
into contact with the blades.
• Turn off the clipper.
• Remove the Comb accessory.
• Turn on the clipper.
• Position the clipper so that only one edge is in contact with the hair.
• Slowly style the hair around the ears and contour the neckline by placing the blades against
the neck and moving them downward.
• For the final haircut, fringe or beard, use scissors (not included
LESS DENSE
LONGER
MORE DENSE
MORE SHORT
EN