IKEA ENHET Посібник з монтажу - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з монтажу для Внутрішнє оздоблення приміщень IKEA ENHET. IKEA ENHET 16 сторінок. Kitchen
Також для IKEA ENHET: Посібник з монтажу (10 сторінок), Посібник з монтажу (20 сторінок)
Друкувати сторінку
Installing base cabinets/frames
Once you have installed the wall cabinets you move
on to the base cabinets. Again, start from the corner
of the room and place the cabinet on the supporting
wooden strip. If you are building a line kitchen, make
sure to leave space between the wall and the cabinet
to allow for doors or drawers to open properly.
If you build a corner base solution with a 40cm door,
place the cabinet 268mm from the wall (A). If you
build it with a 60cm door, place the cabinet 468mm
from the wall (A). In both cases, the adjacent cabinet
is placed 688mm from the wall (B).
As you proceed with the next cabinet, level and align
the two cabinets by using a clamp. Use the screws
provided to attach the adjacent cabinets.
To install a cabinet after the dishwasher niche, make
sure the spirit level reaches both cabinets at the
front and at the back of the cabinets. Make sure the
distance at the front and back of the niche remains
60cm. Once you have the correct alignment, secure
the cabinet to the wall.
8
If you have a corner kitchen, you build the corner base
solution with an 80cm base cabinet in combination
with the ENHET corner panel. For this solution, follow
the assembly instructions included with the ENHET
corner panel.
Note: ENHET open frames can't be used under a sink,
built-in cooktop or for a built-in oven.
Make sure that the corner panel and the front edge
of the adjacent cabinet align.
When you reach the place where you want your sink
and tap, use the ENHET cabinet for sink, which has
a construction that allows for pipes coming from
either the wall or the floor. See assembly instructions
for how to build the different configurations.
When you install an open base frame, you don't use
a supporting strip. Instead, align the top of the open
frame with the top of the adjacent cabinet before
you fix the frame to the wall.
Fix the cabinet using the appropriate type and
length of screw. Throughout the installation process
you may need to loosen the screws to make small
adjustments when aligning cabinets and frames.
The dishwasher, normally placed next to the sink
cabinet, stands on its own base so there is no need
for a supporting strip. Leave a 60cm wide gap
between the sink cabinet and the next cabinet.
Once all your base cabinets are installed, check that
they are level and that you are happy with the result,
before securing them by tightening the screws a
final time.