Bristan Z2 DUS 1/2 C Інструкція з монтажу та посібник користувача
Переглянути онлайн або завантажити pdf Інструкція з монтажу та посібник користувача для Сантехнічний виріб Bristan Z2 DUS 1/2 C. Bristan Z2 DUS 1/2 C 2 сторінки. Tap
Також для Bristan Z2 DUS 1/2 C: Інструкція з монтажу Інструкція з монтажу (12 сторінок)
Друкувати сторінку
Specifications
Maximum Operating Temperature
Dynamic Water Pressure
Min: 0.5 bar
Max: 5.0 bar
3.0
3.0
2.0
2.0
4.0
1.0
4.0
1.0
0.2
5.0
0
5.0
Pressure
Pressure
BAR
BAR
Maximum Static Pressure: 10.0 bar
If the supply pressure is above 3 bar, a
pressure reducing valve must be fitted
Flat screwdriver
Prior to Installation
All products manufactured and supplied by Bristan are safe
provided they are installed, used correctly and recieve regular
maintenance in accordance with these instructions.
This product has been tested to the Water Regulations Advisory
Scheme (WRAS) and satisfies the requirements of the Water
Supply (Water Fittings) Regulations 1999 and current bylaws.
For full Installation Requirements & Notes (IRN)
please visit wras.co.uk/directory.
We recommend isolation valves to be fitted to the inlet water
supplies to ensure ease of future maintenance.
Before installing these taps the water supply must be thoroughly
flushed in order to remove any swarf, solder etc.
This product must not be modified in any way as this will
invalidate the guarantee.
Installation Instructions
& User Guide
Please leave these instructions
with the end user
Product code: Z2 DUS 1/2 C
Inlet Connections
65°C
60°C
60-65°C
recommended
1/2" Male BSP Tap connector
The Flow Valve is timed and will
shut off in 15 ± 5 seconds
*This will vary depending on system pressure
Tools You'll Need
Cross Screwdriver
Adjustable spanner
Pipe cutter
Pack Contents
x1
x1
x1
Basket Filter
washer x1
Spare Parts For Your Tap
To replace any spare parts
for your tap, why not
scan the QR Code or
visit www.bristan.com
and search for your product.
Installation
1
D4
Place the plinths over the holes
in the basin ensuring that the
washers are fitted between the
plinths and the basin.
3
Secure the taps to the basin by
5/Ltr Flow Regulator
using the washer and metal backnut
Pre-Fitted
5
x1
Turn
6
on water
supply for a
few minutes and
check all joints and
Indices
connections for any
x2
leaks.
Blue
Red
Turn on
water
supply
2
Fit the taps to
the basin.
3
4
below the basin
Important
If the supply
pressure is above
3 bar a pressure
reducing valve must
be fitted
Depending
on chosen
hot or cold
water supply,
fit indice
(supplied)
Important
Connect the
Please ensure
hot or cold
that the correct
colour indice is
water supplies
fitted
to the threaded
tails.
Operation
The tap will shut off up to
15
Please fit the
basket filter
washer into the
tail in the order
shown
Push down
to get flow of
water
5 seconds*
±