Bristan Gummers H64WMT Інструкції з монтажу, експлуатації та обслуговування - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкції з монтажу, експлуатації та обслуговування для Сантехніка для кухні та ванної кімнати Bristan Gummers H64WMT. Bristan Gummers H64WMT 6 сторінок. Sequential integral thermostatic bib tap
Друкувати сторінкуIntroduction
The NHS is aware that users of hot water in care establishments can be at risk
from scalding and in order to minimise that risk and reduce the incidence of
legionella thermostatic mixing valves are generally used. To ensure the
performance of these products the NHS Estates Model Engineering Specification
DO8 was written. This product is independently certified to comply with that
specification for use as a hand-washing device on both high and low pressure.
This fitting is designed to have the following advantages: -
1) The temperatures of the exposed surfaces in normal use will not cause
skin damage.
2) Integral in front of panel isolation and union connections allow the
complete unit to be removed for workshop servicing.
3) Integral flushing system allows the mixed water chambers to be
pasteurised reducing the risk of bio film growth.
It can be used in any situation where a thermostatically controlled temperature is
required for hand washing or vessel filling.
This product is approved by Buildcert for the following designations:
Operating Pressure
Code
HP - W
High Pressure
LP - WE
Low pressure Economy
Conditions for normal use
In order ensure the product will perform within the requirements of the TMV3
scheme the operating parameters should comply with the table below, it may
perform adequately outside these limits but an engineer should carry out a risk
assessment to substantiate this.
Maximum Static Pressure
Minimum Dynamic Pressure
Recommended hot supply temperature
Recommended cold supply temperature
Minimal Temperature Differential between Mixed Water
Temperature and Either Supply
Specification
The flow rates (L/min) for the tap with and without flow limiters are quoted in
the table below:
Pressure Drop bar
0.1
0.2
Flow rate without limiters
4
5.8
Flow rate with limiters
W ith Flow Regulators
Application
Wash Basin
Wash Basin
Low
pressure
10 bar
0.2 to 1 bar
52 to 65ºC
5 to 20ºC
10ºC
0.4
0.6
0.8
1
1.5
2
8
10
11.6
12.9
No Flow Regulators
8.5
9
9.3
HTM64 SPARES LISTING
ORDER CODE
SKH64-1
SKH64-2
SKH64-3
SKH64-4
SKH64-5
SKH64-6
SKH64-7
SKH64-8
SKH64-9
SKH64-10
SK1500-3
SK320078
SK740012
NOTES
High
pressure
10 bar
1 to 5 bar
52 to 65ºC
5 to 20ºC
10ºC
3
4
5
9
9
9
DESCRIPTION
O-RING SEALS KIT
CARTRIDGE ASSEMBLY
FLOW STRAIGHTNER
HANDLE ASSEMBLY.
INLET ASSEMBLIES (PAIR)
COLD ELBOW ASSEMBLY (WALL MOUNT)
HOT ELBOW ASSEMBLY (WALL MOUNT)
COLD ELBOW ASSEMBLY (DECK MOUNT)
HOT ELBOW ASSEMBLY (DECK MOUNT)
WALL SHROUDS CHROME (PAIR)
THERMOSTAT & PISTON ASSEMBLY
PISTON ASSEMBLY
THERMOSTAT