Bristan Kingsbury Інструкція з монтажу та посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з монтажу та посібник користувача для Сантехніка для кухні та ванної кімнати Bristan Kingsbury. Bristan Kingsbury 8 сторінок. Monobloc sink mixer
Друкувати сторінку
1. Introduction
1. Introduction
1. Introduction
1. Introduction
Thank you for choosing Bristan, the UK's leading taps and showers expert. We have designed this product with
your enjoyment in mind. To ensure that it works to its full potential, it needs to be fitted correctly. These fitting
instructions have been created to give you all of the information you need and, if you need any further help, please
do not hesitate to give us a call on 0844 701 6273.
2. Safety Note
2. Safety Note
2. Safety Note
2. Safety Note
Please read these instruction thoroughly and retain for future use. All products manufactured and supplied by
Bristan are safe provided they are installed correctly, used correctly and receive regular maintenance in
accordance with these instructions.
These fittings need to be installed in accordance with and meet the requirements of the Water Supply (Water
Fittings) Regulations 1999 and Scottish Byelaws 2004.
3. Specification
3. Specification
3. Specification
3. Specification
Min.
Max.
Operating pressure range (bar)
0.2
8.0
NOTE:- Nominally equal (balanced) inlet supply pressures are recommended for optimum performance.
Designed to comply with BS EN 200 for single taps/ combination taps for water systems of type 1 and 2 general
technical specifications and to be used within systems designed to BS 6700.
BS 6700 recommends the temperature of stored water should never exceed 65°C. A stored water temperature of
60°C is considered sufficient to meet all nominal requirements and will minimise the build up of lime scale in hard
water areas.
This mixer is suitable for use at all supply pressures.
If the fitting is installed at low pressure (tank fed), then the
minimum height from the outlet of the nozzle to the
underside of the cold water tank should be at least at least
2 metres to ensure adequate performance.
This mixer should be in stalled in compliance with the
Water regulations, where the supplies are unbalanced
i.e hot water from a cylinder tank and cold from the
mains. Approved check valves must be fitted in the
supply pipes, for further details contact your Local
Water Authority.
03