Bristan CAP BF C Інструкція з монтажу та посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з монтажу та посібник користувача для Диспенсер для води Bristan CAP BF C. Bristan CAP BF C 12 сторінок.

Друкувати сторінку

5. Installation cont

Bidet Mixer

1. Identify all components are present prior to installation.

2. Install the mixer (6) to the bidet. Secure the mixer to the surface of bidet using the fixing kit

(9) with plinth washer (8) and plinth (7) above the bidet.

3. Screw in connecting copper tail pipes (10) to the mixer by HAND ONLY (DO NOT

OVERTIGHTEN), and then connect hot and cold water supplies.

4. Fit the pop-up waste (11), with the flat washer below and the shaped washer above the bidet.

It is advised that a silicon sealant be applied to both sealing faces of the washers. The plug

height can be set by adjusting the waste rod operating rod, rod connector and then screw in

the base of the plug. Friction for the waste mechanism can be adjusted using the waste cap

(DO NOT OVERTIGHTEN).

5. Turn on the water supplies. Lift and turn handle both ways for a few minutes, letting the

water flow, to check all joints and connections for leaks.

NOTE: The Bidet Mixer is fitted with a directional nozzle.

NOTE:

. . . .