Bristan IRSD1-BN Інструкція з монтажу та посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з монтажу та посібник користувача для Диспенсер Bristan IRSD1-BN. Bristan IRSD1-BN 16 сторінок. Infrared automatic soap dispensor
Також для Bristan IRSD1-BN: Інструкція з монтажу та посібник користувача (16 сторінок)
Друкувати сторінку
Commissioning
Commissioning Sequence
Before using the soap dispenser for
the first time the following sequence
must be carried out.
Fill the bottle full of liquid soap. Refer
to specification section on page 3 for
the correct liquid soap to be used.
Important: Gels/sanitisers
cannot be used, only soap in the
viscosity range of 100-3500cp (mpA
·
s)
Locate the dispense button on the
side of the pump. Press and hold
the button until soap is dispensed
from the spout. This will ensure the
dispenser tube and cable are full of
liquid soap.
Selecting Volume Adjustment
The soap dispenser has four dispense
volume adjustment settings. Each
adjustment setting dispenses a
different volume of liquid soap.
Volume Adjustment
Setting
Low
Normal
Medium
High
To adjust the volume of soap
dispensed follow the steps below.
Locate the volume adjustment
switches under the rubber cover.
Set the switches to the required
position for the desired volume
adjustment setting.
Refer to the switch position diagrams.
Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.
Volume of liquid
soap (ml)
0.5
1
1.5
2
Dispense
Button
Volume Adjustment Switch Positions
Volume
adjustment
Low: 0.5 ml
Switch 1: Off
Switch 2: Off
Normal: 1 ml
Switch 1: Off
Switch 2: On
Midium: 1.5 ml
Switch 1: On
Switch 2: Off
High: 2 ml
Switch 1: On
Switch 2: On
9