Gamma 5003 Посібник користувача - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник користувача для Нанизувальні машини Gamma 5003. Gamma 5003 20 сторінок. 6 point mounting
Також для Gamma 5003: Посібник користувача (19 сторінок), Посібник користувача (20 сторінок), Посібник користувача (20 сторінок)

MAINTENANCE & ADJUSTMENT

Tension Calibration Procedure

Set the tension to 60 lbs. as indicated by the

linear scale and rotary knob. Place the string

on one end of a tension calibrator into a string

clamp and secure. Place string located on

the other end of the calibrator into the string

tensioner and apply tension. If the brake lever

releases before or after 60 lbs., the tension

head should be calibrated as follows.

Loosen the 1.5 mm locking set screw (A)

located on the side of the latching block as

shown. The set screw is used to hold the

adjustment screw in place.

If the lever releases before 60 lbs., using

the supplied L-shaped hex wrench, turn

the adjustment screw (B) located on the left

side of the latch block counter-clockwise to

increase the engagement of the brake release

latch with the brake lever. Repeat step 1 and

adjust until the correct tension is indicated

on the calibrator.

If the tension indicated in step 1 is greater

than 60 lbs., turn the adjustment screw clock-

wise to reduce the engagement of the brake

release latch with the brake lever. Repeat

step 1 and adjust until the correct tension is

indicated on the calibrator.