Gamma 5003 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Нанизувальні машини Gamma 5003. Gamma 5003 20 сторінок. 6 point mounting
Також для Gamma 5003: Посібник користувача (19 сторінок), Посібник користувача (20 сторінок), Посібник користувача (20 сторінок)

ASSEMBLY INSTRUCTIONS

Turntable and Mounting System

Installation

To install the turntable remove the four nuts

holding the mounting bolts in place during

shipment. Position the turntable over the

turntable pin and align the bolts with the

holes in the flange. Secure them with the

included allen wrench.

Caution: If the mounting bolts are removed

or fall out during assembly be sure that the

bolts pass through the spacer inside the

turntable before securing the turntable to

the turntable pin.

String Clamp Installation

The post of the string clamp and tube of the

string clamp base are treated with grease to

provide protection against corrosion during

shipping. Remove any excessive grease with

a clean cloth prior to use. The post and tube

may also be cleaned with isopropyl alcohol.

After this type of thorough cleaning, the post

and tube should be treated with a light coating

of machine oil to protect the surfaces against

corrosion and to ensure smooth operation.

Installing the Tensioner

Remove the button head screw and washer

located at the end of the tensioner bar with

the 3mm hex wrench provided. Slide the

tensioner onto the bar, being careful to align

the bar with all of the bearings and the drive

gear with the gear track. Replace the button

head screw and washer in the end of the

tensioner bar.