Gamma 5003 Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Нанизувальні машини Gamma 5003. Gamma 5003 20 сторінок. 6 point mounting
Також для Gamma 5003: Посібник користувача (20 сторінок), Посібник користувача (19 сторінок), Посібник користувача (20 сторінок)

STRINGING THE FRAME

ADDITIONAL FEATURES

Pulling Tension

Wrap the loose section of string once around

the roller guide and insert the string between

the diamond dust coated string gripper plates.

Pull the string perpendicular to the gripper

plates while slowly rotating the tensioner

crank clockwise until the brake lever pops

out of the latching block. The string is now

tensioned and can be clamped in place with

the remaining fixed clamp.

Repeat the above steps until all main strings

are installed. Tie off ends of main strings as

per racquet manufacturers recommenda-

tions.

Weaving the Cross Strings

Weave the cross strings over and under the

main strings being careful to alternate the

weave direction of each consecutive cross

string so as to be opposite of the previously

installed cross string.

Once the final cross string is tensioned and

clamped, tie off at the appropriate hole speci-

fied by the racquet manufacturer. Remove

the frame from the mounting system by

loosening the shoulder supports and frame

supports.

Locking the Turntable

The turntable may be locked in any position.

The turntable winged lock knob is packed

separately. Install the lock knob into the

threaded hole located on the side of the

tensioner bar post.

Rotate the knob clockwise to lock the turn-

table, and counter-clockwise to release the

turntable.