Gamma 5003 Посібник користувача - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник користувача для Нанизувальні машини Gamma 5003. Gamma 5003 20 сторінок. 6 point mounting
Також для Gamma 5003: Посібник користувача (20 сторінок), Посібник користувача (19 сторінок), Посібник користувача (20 сторінок)

aligns with the line on the knob support. To decrease tension by 1 or 2 lbs, turn the knob

clockwise until the "2" or "1" mark on the knob aligns with the line on the knob support.

increased friction between the clamps and the string to allow for reduced clamping pressure

while securing and holding the string under tension.

STRINGING THE FRAME

Travel Stop

Setting Tension

The tensioner utilizes a rotary adjusting knob

along with a linear tension scale to indicate

the tension setting. The scale is divided into

3 lb increments and each 1/3 turn of the

tension knob changes tension by 1 lb. To set

the desired tension, rotate the tension knob

and align the mark on the spring guide with

the desired tension setting on the scale.

When the "0" mark on the knob aligns with the

line on the knob support the tension will be

that indicated on the scale. To increase

tension by 1 or 2 lbs turn the knob counter-

clockwise until the "1" or "2" mark on the knob

Tensioner Travel Stop

To prevent contact between the tension

head and the racquet and/or turntable, a

travel stop is located about midpoint along

the tensioner bar below the gear track. In the

event the tension head must be moved closer

to the racquet, pull and turn the travel stop 90

degrees.

To re-engage the travel stop,

simply pull and turn the travel stop 90 de-

grees.

Clamp Head Operation

GAMMA "Quick Action" Clamps are of a dual

action design where as the clamp head and

clamp base operate independently of one

another.

To clamp a string, lift the clamp head and

place the string between the jaws and de-

press the clamp head lever to secure the

string. The clamping pressure applied to the

string should be adjusted to provide suffi-

cient pressure to secure the string when

subjected to the desired pulling tension. The

diamond coated gripper plates provide for