Gamma 6002 Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Нанизувальні машини Gamma 6002. Gamma 6002 20 сторінок.

ASSEMBLY INSTRUCTIONS

Turntable Brake Installation

Remove the flat head screw from the end of

the brake lever bolt and install the brake lever

bolt into the threaded hole located on the side

of the turntable tube.

Place the brake pad into the turntable tube,

then insert the end of the brake leverbolt into

the hole of the brake pad so that the brake

pad rests on the shoulder of the bolt.

Insert the flat head screw into the end of the

brake lever bolt from the inner side of the

brake pad. While holding the head of the

screw with the 2.5mm L-shaped wrench,

turn the lever bolt to secure the brake pad

against the shoulder of the lever bolt and set

the head of the screw below the inner

surface of the brake pad. turn the lever to

retract the pad until it sets against the inner

surface of the turntable tube to provide

clearance for installation of the turntable.