Gamma 6004 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Нанизувальні машини Gamma 6004. Gamma 6004 20 сторінок. 6 point mounting
Також для Gamma 6004: Посібник користувача (20 сторінок), Посібник користувача (20 сторінок), Посібник користувача (19 сторінок)

ASSEMBLY INSTRUCTIONS

Turntable and Mounting System

Installation

To install the turntable remove the four nuts

holding the mounting bolts in place during

shipment. Position the turntable over the

turntable pin and align the bolts with the holes

in the flange. Secure them with the included

allen wrench.

Caution: If the mounting bolts are removed

or fall out during assembly be sure that the

bolts pass through the spacer inside the

turntable before securing the turntable to

the turntable pin.

String Clamp Installation

The post of the string clamp and tube of the

string clamp base are treated with grease to

provide protection against corrosion during

shipping. Remove any excessive grease with

a clean cloth prior to use. The post and tube

may also be cleaned with isopropyl alcohol.

After this type of thorough cleaning, the post

and tube should be treated with a light coating

of machine oil to protect the surfaces against

corrosion and to ensure smooth operation.

Tensioner Installation

Remove the button head screw and washer

located at the end of the tensioner bar with the

3mm hex wrench provided. Slide the tensioner

onto the bar, being careful to align the bar with

all of the bearings and the drive gear with the

gear track. Replace the button head screw

and washer in the end of the tensioner bar.