Gamma Progression 600FC Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Нанизувальні машини Gamma Progression 600FC. Gamma Progression 600FC 15 сторінок.

STRINGING THE FRAME

Setting Tension

To set the stringing tension, loosen the

locking knob on the side of the drop weight.

Slide the weight in the appropriate direction

until the face closest to the string gripper is

indexed with the desired tension mark on the

tension bar.

The drop weight is of a two piece design.

When assembled, it will accomodate ten-

sions from 20 lbs. to 90 lbs. For tensions from

8 to 20 lbs., remove the 5mm bolt on the face

of the drop weight, and use the smaller

portion of the weight as described above.

Note: Tensions above 77lbs. require re-

moval of the drop weight bar endcap.

Clamping the First Main String

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and pull

excess by hand. Using a floating clamp,

secure the center and the adjacent string to

each other on the inside of the frame.