Gamma SPEKTRA ZOOM/200W FRESNEL LED Інструкція користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція користувача для Ді-джейське обладнання Gamma SPEKTRA ZOOM/200W FRESNEL LED. Gamma SPEKTRA ZOOM/200W FRESNEL LED 7 сторінок.
3-Pin to 5-Pin Conversion Chart:
Note!
If you use a controller with a 5 pin DMX output connector,you will need to use a 5 pin to 3
pin adapter. The chart below details a proper cable conversion:
Conductor
Ground/Shield
Data(-) signal
Data(+) signal
Not Used
Not Used
Setting up a DMX Serial Data Link:
Master/Slave Fixture Linking:
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin
connector of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector.
Then, proceed to connect from the output as stated above to the input of the following fixture
and so on.
4. DMX Channels Summary
4.1 Operation method
1.
keystrokes
3-Pin to 5-Pin Conversion
3 Pin Female(Output)
2.
Pin 1
Pin 2
Pin 3
Basic usage
5 Pin Male(Input)
Pin 1
Pin 2
Pin 3
Do not use
Do not use
Led Par Light