Gamma X-Stringer XLT Посібник користувача - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари Gamma X-Stringer XLT. Gamma X-Stringer XLT 20 сторінок. Electronic stringing machine
Друкувати сторінку
MAINTENANCE & ADJUSTMENTS
Adjustment
Knob
the string, it may be excessively tight and should be adjusted by turning the Adjustment Knob
counter clockwise to open the gap between the jaws.
NOTE: Due to the bearings used in the Clamp Lever the action of the Clamp Lever is
very light making it easy to apply excessive clamping pressure. Clamps that are set
too tight can damage the string as well as the string clamp jaws.
The clamp jaws should be cleaned periodically to be free from dirt, oil, and any string coating
residue to grip properly. Knife sharpening stones are excellent for removing build-up on the
diamond coated surfaces and are available.
Adjusting the String Clamp Jaw
Spacing
The string clamps will need minor adjust-
ments according to what string type, con-
struction, and gauge you are using.
To adjust the gap (clamping pressure)
between the clamp jaws, insert the string
through the racquet as if you were beginning
the main strings. Clamp the strings and pull
tension. If the string slips through the jaws of
the clamp, tighten the clamp by squeezing the
clamp jaws together by hand while turning the
Adjustment Knob, in the clockwise direction.
If the clamp leaves impressions or damages
Clamp Base Locking Nut Adjustment
In the event the Locking Lever rotation is insuf-
fi cient to ensure smooth operation of the clamp
base, very minor adjustments to the Clamp Base
Locking Nut can be made with the supplied
17mm socket. Tighten or loosen the locking nut
in very small increments to provide more clamp-
ing pressure or running clearance as needed.
Quick Action Clamp Base Removal
Quick Action clamp bases can be removed
from the turntable for maintenance or cleaning
by removing clamp stop located at the end of
the slot in the turntable. To remove the clamp
stop, remove the two screws holding the clamp
stop in place from the underside of the turn-
table. Lift the clamp stop out of the slot, slide
the clamp base to the end of the slot and lift it
out. Replace the clamp base and clamp stop
in reverse order.
16