decina CASCADE CASS1000C Інструкція з експлуатації - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Сантехніка для ванної кімнати decina CASCADE CASS1000C. decina CASCADE CASS1000C 7 сторінок.

Друкувати сторінку

Important Pre-Installation Information

- Please read this entire instruction book before commencing installation.

- A licenced tradesman must be used for the installation.

- Ensure there is a gasket between all glass and metal components.

- Leave the plastic protectors on the glass corners until the last possible moment

and handle with care.

- Instructions to install the shower tray are included with the shower tray.

- In cold climates, warming the gaskets and seals with hot water or a hairdryer will

assist installation.

- On symmetrical pieces of glass, the EZI Clean coating is only on one face. This

face will have a sticker on it to identify it. This side must be installed on the wet

side of the shower.

Maintenance

- The use of harsh or abrasive cleaners will cause deterioration of the EZI Clean

coating. If water alone is not enough to clean the glass, Decina recommends the

use of mild detergent solutions only.

Tools Required

Silicone Sealant

Pencil

Utility Knife

* Use the correct type of drill bit for the material being drilled, with 6mm required for anchor ﬁxing and 3mm used for

screwing directly into the wall studs.

** As with all toughened glass, take care while handling and wear safety goggles and gloves for personal protection.

Drill

Phillips Screwdriver

6mm (1/4") and

3mm (1/8") Drill Bits

Level

Tape Measure

Safety Goggles

Rubber Mallet

Cutting Pliers

Gloves