decina Luna 1000 SB1000R3T Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу для Сантехніка для ванної кімнати decina Luna 1000 SB1000R3T. decina Luna 1000 SB1000R3T 11 сторінок. Shower bases & acrylic shower wall

Друкувати сторінку

COMPLIANCE REQUIREMENTS

Any wet area installation or renovation must comply with the following:

BUILDING CODE OF AUSTRALIA

VOLUME ONE - CLASS 2 - 9 BUILDINGS

VOLUME TWO - CLASS 1 AND CLASS 10 BUILDINGS - HOUSING

PROVISIONS

BCA 2006 Voume One references AS 3740 - 'Waterproofing of wet areas in

•

residential buildings' as meeting the minimum performance requirements for

construction of wet areas in Class 2, 3 and 4 buildings.

BCA 2006 Voume Two gives detailed waterproofing requirements for various

•

applications. These requirements are for all intents and purposes the same as

those provided in AS 3740.

AUSTRALIAN STANDARD 3740- 2010

Waterproofing of Domestic Wet Areas

•

This standard specifies the requirements for the physical elements of construction

including floors, walls, junctions and penetration and the specific areas where

these criteria apply including showers.

S H OWE R IN STA LLATI O N G U I D E

AREA PREPARATION

To ensure correct installation of Decina

shower products, it is important to have

the site floor and walls; level; square

and plumb to within 5mm overall.

TO NOT DO SO MAY PREVENT

CORRECT FITMENT OF A

DECINA GLASS SHOWER SCREEN

ONTO THE LUNA SHOWER BASE OR

TILES AND MAY AFFECT WATER

DRAINAGE OF THE SHOWER BASE.

To ensure proper bond of the Decina

•

shower products, the floor and wall

area must be smooth, clean, dry,

unpainted and unsealed.

For shower wall applications,

•

installation can only be on new wet

area sheets, to ensure effective bond

of the adhesives and sealants.

All floor and wall surface joints and

•

fixings must be flush to prevent

unevenness on the Decina shower

products, potentially causing stress

points or unsightly bulges.

Decina shower bases and shower

•

walls must be fitted to a structurally

sound solid surface that does not

flex under load. This will prevent

unevenness in the product or potential

weak spots.

SH OW ER I NS TA LLATI O N G UI DE