Gamma Sports Els Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Нанизувальні машини Gamma Sports Els. Gamma Sports Els 10 сторінок.

Друкувати сторінку

ADDITIONAL FEATURES

Turntable Brake

The turntable may be locked in any position.

Rotate the lever to the right to lock the turn-

table and to the left to release the turntable.

Badminton Shoulder Support Protec-

tion Pad Installation

Slide the badminton shoulder support cover

over the shoulder supports. There is no need

to remove the tennis shoulder supports.

Note: An optional badminton frame support

for the head of the racquet is available.

STRINGING THE FRAME

to allow for reduced clamping pressure while securing and holding the string under tension.

Clamp Base Operation

To lock the string clamp base to the turntable,

rotate the clamp base locking lever clockwise.

To release the string clamp base from the

turntable, rotate the clamp base locking lever

counter-clockwise.

The Locking Lever should be tightened

enough to prevent clamp base slippage on

the turntable, when the desired tension is

placed on the string. To go from the loose

position to the clamped position and back,

generally requires the rotation permitted by

the slot in the clamp base.

String Clamp Operation

The string c

lamps are a dual action design

where the string clamp and clamp base oper-

ate independently of one another.

To clamp a string, lift the clamp head and

place the string between the jaws and de-

press the string clamp lever to secure the

string. The clamping pressure applied to the

string should be adjusted to provide sufﬁ cient

pressure to secure the string when subjected

to the desired pulling tension. The diamond

coated gripper plates provide for increased

friction between the clamps and the string

Getting Started

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and pull

excess by hand.

Secure one of the strings using a string clamp.