Centsys Photon SMART Посібник з монтажу - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з монтажу для Датчики безпеки Centsys Photon SMART. Centsys Photon SMART 8 сторінок.
Друкувати сторінку1.
Once it is connected, it will provide the option to
give the Photon SMART pair a custom name.
The beam lenses MUST be fitted on the
receiver during the alignment procedure
as they serve to focus the infrared beam.
Failure to do so may result in an inability to
achieve alignment. Refer to Figure 11.
Do not screw closed until the beams have
been aligned.
2.
Tap NEXT, and the alignment process will begin.
The transmitter's position may need to be adjusted
until alignment is achieved. A minimimum of 10
seconds alignment is needed before being able to
proceed.
3.
Once alignment is acheived, mark the location of
the transmitter on the mounting surface.
4.
To prevent damage, switch off the transmitter.
5.
Mount the transmitter following steps in
Section 7.3, and switch on the transmitter.
6.
Tap next, and finish.
7.
The paired Photon SMART PE beams will be seen
under the IRB Photon SMART screen.
9. Completing the Installation
9.1 Closing
Close the units by placing the front cover onto the base
as shown in Figure 10. Do not force the cover, rather
place it over as illustrated.
Bottom
Cover
Insert and fasten the "shorter" screw provided to
close the two enclosures together, followed by inserting
the plastic cover provided as shown in Figure 12.
Front
Cover
FIGURE 10