aguri 50502 Інструкція

Переглянути онлайн або завантажити pdf Інструкція для Автомобільні аксесуари aguri 50502. aguri 50502 2 сторінки. Roof box

ASSEMBLY PARTS

ACTUATOR - 2PCS

PIN HINGE - 3PCS

KNOB BRACKET - 8PCS

BOX ASSEMBLY

1. Remove the box from the cardboard. All mounting parts are located in the bag placed at the base of the box.

2. Position the bottom of the box on a flat surface and place the cover on top of the box.

3. Prepare the hinge pins. Use the pins to connect the lid hinges with the base of the box in three spots (fig. 1).

Note the correct push pins.

Fig. 1

4. Extend the arms of the actuator. Press the orange actuator latch lock and place the hook on the spindle in the base.

Release the orange lock. Connect the second end of the actuator to the base of the box in the same way (fig 3).

Repeat this with the second actuator. The actuators should connect the base of the box with the cover (fig. 4).

ACTUATOR

Fig.3

Fig. 4

CAR ASSEMBLY

1. If you have a black or silver metallic box remove the protective foil.

2. Put the box on the car roof. Make sure you alight the box correctly (Fig. 5).

The base of the box contains 4 holes (Fig. 6). Place the box so that the beam is located between two of them. Given the length of the

box and the roof of the car, choose which hole to use when connecting the beam. This applies to both beams. Remember that the box

should not protrude beyond the roof of the car.

3. Install the mounting brackets starting with the bottom of the base, putting the brackets around the beam and placing the ends inside the

holes at the base of the box (Fig. 7). Apply pressure and tighten the knob to fix the bracket (Fig. 8). Repeat these steps for all 4 mounting

points (Fig. 9).

4. Insert the baggage strap in the oblong hole inside the fixing clamp (Fig. 10) in order to prevent the luggage from shifting while driving.

Remember the correctly alight the load inside the box (Fig. 14).

Tighten the lid and lock the box (Fig. 11 - 13).

COMFORTABLE TRAVELING

ROOF BOX

WIND 32, WIND 43

50502 WIND 32 BLACK, 50500 WIND 32 GREY, 50501 WIND32 SILVER

50508 WIND 43 BLACK, 50506 WIND 43 GREY, 50507 WIND 43 SILVER

Hinges 3X

Fig. 2

MOUNTING BRACKET - 4PCS

MOUNTING PRESSURE - 4PCS

LUGGAGE STRAP 2,5M - 2PCS

ACTUATOR

The box can be mounted on

rectangular and T-shaped racks.