KitchenAid Architect Series II KGRS807S Розміри

Переглянути онлайн або завантажити pdf Розміри для Варильна поверхня KitchenAid Architect Series II KGRS807S. KitchenAid Architect Series II KGRS807S 1 сторінка. 30" freestanding and slide-in gas range
Також для KitchenAid Architect Series II KGRS807S: Розміри (1 сторінок)

Друкувати сторінку
PRODUCT MODEL NUMBERS
KGRS807S
KGSS907S
KGRS807X
KGSS907X
KGSK901S
GAS SUPPLY REQUIREMENTS
Use
" (1.9 cm) rigid pipe gas supply line to
the range location. A smaller size pipe on long
runs may result in insufficient gas supply. With
LP gas, piping or tubing size can be
(1.3 cm) minimum. If local codes permit, it is
recommended that new flexible metal tubing,
design-certified by CSA, 4-5 ft (122-152.4 cm)
long,
" (1.3 cm) or
" (1.9 cm) I.D., be used
for connecting the range to the rigid gas supply
line. A
" (1.3 cm) male pipe thread is needed
for connection to pressure regulator female
pipe threads. An easily accessible individual
manual shutoff valve must be located in the
same room, but external to the range.
ELECTRICAL REQUIREMENTS
120-volt, 60 Hz, AC-only, 15 amp, fused
electrical circuit is required. A separate circuit
is recommended. A time-delay fuse or circuit
breaker is recommended.
SLIDE-IN RANGE COUNTERTOP PREPARATION
The cooktop sides of the slide-in range fit over
the cutout edge of your countertop.
If you have a square finish (flat) countertop and
the opening width is 30" (76.2 cm), no
countertop preparation is required.
Formed front-edged countertops must have
molded edge shaved flat
" (1.0 cm) from each
front corner of opening.
CABINET OPENING DIMENSIONS
13" (33 cm) upper
cabinet depth
30" (76.2 cm) min.
opening width
18" (45.7 cm)
30" (76.2 cm)
upper cabinet
min. opening
to countertop
width
Grounded
outlet
5" (12.7 cm) min.
(15.2 cm)
clearance from
6"
both sides of the
range to the side
(15.2 cm)
wall or other
7" (17.8 cm)
combustible
material.
Available area
for gas and electric
installation.
This shaded area
recommended for
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
®
30" Freestanding and Slide-In Gas Range
OVERALL DIMENSIONS
A
"
A.
" (14.6 cm)
B. 30" (76.2 cm)
C. 41 " (106 cm) overall height
with leveling legs screwed all
the way in.
D. 36" (91.4 cm) cooktop trim
height with leveling legs
screwed all the way in*
*Range can be raised approximately 1" (2.5 cm) by adjusting
the leveling legs.
**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm)
countertop; front of oven door protrudes 1" (2.5 cm) beyond
24" (61 cm) base cabinet.
Tile countertops may need trim cut back
(1.0 cm) from each front corner and/or rounded
edge flattened.
If countertop opening width is greater than 30"
(76.2 cm), adjust the
Countertop must be level. Place level on
countertop, first side to side; then front to back.
If countertop is not level, range will not be level.
Range must be level for satisfactory baking
conditions.
For minimum
clearance to top
of the cooktop,
see NOTE.
Cabinet door
This shaded area
6"
or hinge
recommended for
should not
installation of
extend into
outlet or
the cutout.
junction box.
installation of
rigid gas pipe.
Freestanding Range
B
D*
F**
E. Model/serial number plate
(located on the right-hand
side oven door trim)
F. 27 " (69.2 cm) max. from
handle to standoff at back
of range**
" (1.0 cm) dimension.
13" (33 cm) max.
upper cabinet depth
30" (76.2 cm) min.
opening width
18" (45.7 cm)
upper cabinet
to countertop
5" (12.7 cm) min.
(15.2 cm)
clearance from
both sides of the
6"
range to the side
(15.2 cm)
wall or other
combustible
7" (17.8 cm)
material.
This shaded area
recommended for
installation of
rigid gas pipe.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Slide-in Range
A
F
C
E
E**
A. 30
" (77.6 cm)
B. 35 " (90.5 cm) height to
underside of cooktop edge
with leveling legs screwed
all the way in*
C. Model/serial number plate
(located on the right-hand
side oven door trim)
*Range can be raised approximately 1" (2.5 cm) by adjusting
the leveling legs.
**
"
30"
(76.2 cm)
For minimum
clearance to top
of the cooktop,
see NOTE.
22
" (58.3 cm)
opening depth
30" (76.2 cm)
min. opening
width
Grounded
outlet
Cabinet door
6"
This shaded area
or hinge
recommended for
should not
installation of
extend into
the cutout.
outlet or
junction box.
Available area
for gas and
electric
installation.
B*
C
D
D 30" (76.2 cm)
on models KGRS807XSP and
KGSS907XSP) from handle to
standoff at back of range**
F. 23" (58.4 cm) countertop
notch to rear of cooktop
"
(1.0 cm)
30
"
(78.1 cm)
NOTE: 24" (61 cm)
minimum when bottom of
wood or metal cabinet is
covered by not less than
"
(0.64 cm) flame retardant
millboard covered with not
less than No. 28 MSG sheet
steel, 0.015" (0.4 mm)
stainless steel, 0.024"
(0.6 mm) aluminum or
0.020" (0.5 mm) copper.
30" (76.2 cm) minimum
clearance between the top of
the cooking platform and the
bottom of an uncovered
wood or metal cabinet.
If installing a range hood or
microwave hood combination
above the range, follow the
range hood or microwave
hood combination installation
instructions for dimensional
clearances above the cooktop
surface.
Ref. W10246118C
1/28/11