IKEA 103.810.23 Посібник - Сторінка 29

Переглянути онлайн або завантажити pdf Посібник для Духовка. IKEA 103.810.23. IKEA 103.810.23 36 сторінок. Built-in electrical oven

Друкувати сторінку

ENGLISH

To refit the door

1. Insert the hinges in their seats.

2. Open the door fully.

3. Lower the two catches.

4. Close the door

Cleaning the glass

1. After removing the door and resting

it on a soft surface with the handle

downwards, simultaneously press the

two retaining clips and remove the

upper edge of the door by pulling it

towards you.

Fig. 2

Fig. 3

Fig. 4

2. Lift and firmly hold the inner glass with

both hands, remove it and place it on a

soft surface before cleaning it.

3. To reposition the internal glass properly,

be sure that the "R" can be seen in the

left corner.

First insert the long side of the glass

indicated by "R" into the support seats,

then lower it into position.

4. Refit the upper edge: A click will indicate

correct positioning. Make sure the seal is

secure before refitting the door.

To replace the lamp

1. Disconnect the oven from the power

supply.

2. Unscrew the lamp cover (Fig. 5), replace

the lamp (see note for lamp type) and

screw the lamp cover back on.

3. Reconnect the oven to the power supply.

NOTE:

Only use 25W/230 V type G9, T300°C

halogen lamps.

The lamp used in the appliance is

specifically designed for electrical

appliances and it is not suitable

for household room illumination

(Commission Regulation (EC) No

244/2009).

Lamps are available from IKEA

Authorized Service Centre.

Fig. 5