Centurion R3 Посібник з швидкого налаштування - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник з швидкого налаштування для Відкривач воріт Centurion R3. Centurion R3 19 сторінок. Rotary swing gate operator
Також для Centurion R3: Посібник з швидкого налаштування (2 сторінок), Посібник з швидкого налаштування (17 сторінок)

WARNING

ONNECT ALL

Connect all cables as required to the control card and battery charger (See

Figure 11 & 12). (IM page 48 & 49)

Check that the power source jumper is in the correct position. (PSU or STD

refer to IM page 27, Fig. 24)

Isolator

Box

To dwelling

Figure 9 Cabling Requirements

1. Always check that the circuit breaker in the electrical panel is in the

OFF position, and that all high voltage circuits (more than 42.4V) are

completely isolated from the mains supply before doing any work.

2. Ensure that all low voltage systems (Less than 42.4V) are suitably

protected from damage, by disconnecting all sources of power such

as chargers and batteries before doing any work.

3. All electrical work must be carried out according to the requirements

of all applicable local electrical codes.(It is recommended that a

licensed electrical contractor perform such work.)

IRING

Electrical Set-Up