AFRISO VA-ALERT W Інструкція з монтажу Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Система безпеки AFRISO VA-ALERT W. AFRISO VA-ALERT W 8 сторінок. Full tank alarm for sewage tanks

Друкувати сторінку

Installation

Installation should be done by qualified and

competent electrician.

Mounting the probe:

For the probe through the tank connection

and screw the sensor connector in the

cistern sleeve.

Insert the cable through the gland and

connect the sensor cable as shown below.

Insert the batteries and slide the circuit

board into the housing. Press the lid and

tighten the cable gland.

Install the mounting bracket in a suitable

place in the tank neck during the manhole

cover. See picture below. Use the supplied

plugs and screws.

Mounted on the far side in relation to the

receiver for best signal.

Subject to design modifications.

AFRISO EMA AB • Kilvägen 2, 232 37 Arlöv, Sweden • Tel +46-40-92 20 50 • [email protected] • www.afriso.se

Full Tank Alarm for sewage tanks • Installation instructions

Place the transmitter electronics of the

holder and close the holder. Place the elec-

tronics with the cable pointing downwards

and a position as high up as possible in the

well to ensure that good scope as possible.

See picture below.

Placing the sensor in the tank is suitably in

the sleeve on the tank. The sensor has

a 1" connection. Height tank is adjusted by

sliding the sensor to the desired position

and fixed bytighten the adjustment screw in

1" terminal. Depending on the type of tank/

neck tank sensor may have to be mounted

in other ways. For instructions, contact the

tank manufacturer. See examples below.

VA-ALERT W