Centurion SECTOR II Посібник з монтажу - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник з монтажу для Автоматичні шлагбауми Centurion SECTOR II. Centurion SECTOR II 19 сторінок. Rectangular boom pole jack-knife led
Друкувати сторінкуSECTION 1
1. Introduction
ATTENTION!
To ensure the safety of people and possessions, it is important that
you read all of the following instructions.
Incorrect installation or incorrect use of the product could cause
serious harm to people.
The installer, being either professional or DIY, is the last person on
the site who can ensure that the operator is safely installed and that
the whole system can be operated safely.
Warnings for the Installer
CAREFULLY READ AND FOLLOW ALL INSTRUCTIONS before installing the
product.
•
All installation, repair, and service work to this product must be carried out by a
suitably qualified person
•
Do not activate your barrier unless you can see it and can determine that its area of
travel is clear of people, pets, or other obstructions
•
NO ONE MAY CROSS THE PATH OF A MOVING BARRIER. Always keep people and
objects away from the barrier and its area of travel
•
NEVER LET CHILDREN OPERATE OR PLAY WITH THE BARRIER CONTROLS
•
Secure all easily-accessed barrier controls in order to prevent unauthorised use of the
barrier
•
Do not in any way modify the components of the automated system
•
Do not install the equipment in an explosive atmosphere: the presence of flammable
gasses or fumes is a serious danger to safety
•
Before attempting any work on the system, cut electrical power to the operator and
disconnect the batteries
•
Always ensure that the boom pole is in the raised position before disconnecting AC
and DC power to the Traffic barrier to prevent damage to the controller
•
The mains power supply of the automated system must be fitted with an all-pole
switch with contact opening distance of 3mm or greater. Use of a 5A thermal breaker
with all-pole circuit break is recommended
•
Make sure that an earth leakage circuit breaker with a threshold of 30mA is fitted
upstream of the system
•
Never short-circuit the battery and do not try to recharge the batteries with power
supply units other than that supplied with the product, or manufactured by Centurion
Systems (Pty) Ltd
•
Make sure that the earthing system is correctly constructed, and that all metal parts
of the system are suitably earthed
page 4
INTRODUCTION
www.centsys.com