Brita WD 3050 Інструкція з використання Посібник з використання - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з використання Посібник з використання для Диспенсер Brita WD 3050. Brita WD 3050 17 сторінок.
Друкувати сторінку
3.2
Step 2: Starting the BRITA Cartridge
Status Indicator
The BRITA Cartridge Status Indicator reminds you through three dif-
ferent coloured flashing lights when to exchange the filter cartridge.
A Commissioning:
Remove the battery strip (fig. 4). All LEDs should flash shortly.
Close the compartment. Keep the Reset Button pushed down for
three seconds until a small green light flashes three times at the
top.
B Initial programming of the BRITA Cartridge Status
Indicator:
Depending on the setting you chose for the filter head (step
1), you will programm the BRITA Cartridge Status Indicator as
follows (see fig. 5):
a Push the button on the right side (HARDNESS) to choose the
water hardness. If you push the button once, two yellow LEDs
will flash (default hardness setting: B). Then push the button until
your correct water hardness setting appears:
To choose the water hardness setting C, push the button until
one yellow LED flashes.
To choose the water hardness setting B, push the button until
two yellow LEDs flash.
To choose the water hardness setting A, push the button until
three yellow LEDs flash (see table below).
6
ENGLISH
(fig. 4)
b Push the button on the left side (CARTRIDGE) to set the car-
tridge you are using. If you push the button once, two yellow
LEDs will flash (default cartridge setting: P 1000). Then push the
button until the correct setting for filter cartridge appears:
If you are using the filter cartridge A 1000, push the button, until
one yellow LED flashes.
If you are using the filter cartridge P 1000, push the button, until
two yellow LEDs flash.
If you are using the filter cartridge P 3000, push the button, until
three yellow LEDs flash (see table below).
c To change a setting, simply push the button until the right
n umber of lights are flashing.
d Insert the BRITA Cartridge Status Indicator into the BRITA
branded lever (see fig. 4).
water hardness setting (HARDNESS) C
cartridge setting (CARTRIDGE)
C How the BRITA Cartridge Status Indicator works
To ensure optimal performance, you should change the filter
cartridge on a regular basis. The BRITA Cartridge Status Indicator in
the BRITA lever tells you when to change the filter cartridge.
D Signals
The three lights in the BRITA branded lever are only activated in the
filtering position. They indicate:
- Green light: The BRITA filter is working at optimum performance.
1. Cartridge Button
2. Hardness Button
3. Reset Button
(fig. 5)
1 LED
2 LEDs 3 LEDs
B
A
A 1000 P 1000 P 3000