Gammill PLUS Посібник - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник для Швейна машина Gammill PLUS. Gammill PLUS 12 сторінок.
Друкувати сторінкуgives you even stitch length. Slowing
down produces smaller stitches and
speeding up produces bigger
stitches.
To stop sewing press and release
the run/stop switch. Immediately
after releasing the switch the motor
stops. When the motor stops the
needle returns to the position in
which it was started.
Thread Break Detection
The Plus line of sewing heads
includes a thread break sensor
wheel. The top thread should be
wrapped around this sensor wheel
when threading the machine. In
either automatic or constant speed
mode, if the top thread breaks as
you are sewing, the sensor no longer
turns and a beeper sounds
continuously until the run/stop switch
is pressed. The words "Main Thread
Breakage Detected" are displayed
on the screen notifying you of a
thread break.
To stop the beeps, press and
release the run/stop switch. The
thread break sensor will continue
sensing a thread break during the
next sewing cycle. To disable the
thread break sensor, press the M
button on the display unit. Sensing is
then disabled until the machine is
turned off.
Low Bobbin Sensing
The bobbin thread is used up at the
same rate as the top thread. A
bobbin usage gauge is included in
the Plus line of quilting machines.
This estimation is based on the
bobbin being full and consistently
wound. To obtain the most accurate
bobbin usage you should clip the top
and bottom threads at the same
time. If the top thread is cut and the
bobbin thread is allowed to spool off
when the machine is moved, the
bobbin thread will run out before the
system alerts you it is low.
When the bobbin gauge determines
that the bobbin thread is low the low
bobbin alert beeps continuously until
the run/stop switch is pressed and
released.
To turn off the bobbin sensor press
the M button on the display. Bobbin
sensing will then be disabled until
the machine is turned off.
To Check Amount of
Bobbin Thread Remaining
Press and hold the M button then
press and hold the A button.
Release the M button and then
release the A button. The remaining
value of the bobbin thread is
displayed. If the value is low, you
may wish to insert a full bobbin
before continuing. You may wish to
have a full bobbin before stitching
the next row of an allover design to
avoid running out of bobbin in the
middle of the row.
If you change the bobbin you will
need to reset the bobbin counter by
pressing the + (plus) button. If you
do not change the bobbin press the
– (minus) button to exit the bobbin
counter without resetting it. The
bobbin counter should be reset each
time the bobbin is changed.
4