CenturionPro 3.0 Посібник користувача - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник користувача для Тример CenturionPro 3.0. CenturionPro 3.0 20 сторінок. Elite trimming technologies automated trimming system
Друкувати сторінкуBLADE REMOVAL
For optimal performance and life, the BLADE and the MAGNET BAR must be removed and cleaned every few hours of operation.
STEP 1:
UNLOCK BLADE
- Remove 3/32" bolt
- Loosen the surrounding set screws ONLY
IMPORTANT NOTE:
YOUR BED BAR BLADE HAS BEEN FACTORY SET TO CUT PERFECTLY. PLEASE DO NOT ALTER THE SETTINGS OF YOUR MACHINE. YOU
MIGHT NOTICE SLIGHT CONTACT BETWEEN YOUR ROTATING CUTTLING REEL AND THE FLAT BED BAR BLADE - THIS IS NORMAL.
CLEANING THE 3.0
For optimal performance and life, the components must be cleaned every 3 to 4 hours.
STEP 1:
UNLOCK
BLADE
Clean the length
of the brush of all
debris using hot
pressurized water.
IMPORTANT NOTE:
- Clean by spraying hot pressurized water: 1500 - 2000 psi
- Run the 3.0 for 15 mins after washing to allow components to dry
- DO NOT spray Quantanium Coated tumblers (see page. 12)
10
1 855 535 0558
STEP 2:
UNPIN BLADE
- Pivot the pin up from the blade
STEP 2:
CLEAN
ELECTROPLISH
TUMBLER
Clean the length of
the tumbler of all
debris using hot
pressurized water.
cprosolutions.com
CLEANING & MAINTENANCE
STEP 3:
BLADE & MAGNET REMOVAL
- Carefully slide blade off magnets
- Carefully Remove bed bar blade
STEP 3:
CLEAN CUTTING
REEL & SHROUD
Clean the length of the
cutting reel and shroud
of all debris using hot
pressurized water.
STEP 4:
BLADE & MAGNET CLEANING
- Clean blade and magnet bar with a utility knife.
INSTALLATION IS REVERSE ORDER OF REMOVAL
AVOID
WATER
ON THE
MOTOR