Airflow QuietAir QT 100T Посібник з монтажу та експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Вентилятор Airflow QuietAir QT 100T. Airflow QuietAir QT 100T 8 сторінок. 100mm axial fan
Також для Airflow QuietAir QT 100T: Інструкція з монтажу та експлуатації (5 сторінок)
Друкувати сторінку
Model_QT_100T 27/05/2009 16:51 Page 2
Installation and Operation Instructions
3.3
Wall or ceiling installation
fig.4
With installation of the device, the
guide vane (5) must be mounted
vertically (as shown). Snaps into
place every 90° rotation.
5
vertical
3.4
Cable connections
1.
Pull cable through grommet, don't cut open!
2.
Cut cable at least to length 180 mm and remove cable jacket at least 100 mm in length.
3.
Connect fan according to wiring diagram (see page 5).
4.
Run cable in the conduit.
fig.6
3
7 mm
100 mm
- Length of single conductor 100 mm
- Length of stripped insulation 7 mm
- Strip plastic-sheathed cable flush with conduit.
fig.8
Duct channel
90° bend
Assembly at cramped
place conditions
fig.5
Affix the
rubber foam
1
Back
Break out entry
draught
knockout for cable.
shutter (6)
removable
If installed in the ceiling the pre-cut drillings (2)
must be punched through because of possible
Guide vane (5)
removable
condensate formation.
fig.7
1
1. Press cover of control board (2) on casing and
fasten with screws.
2. Snap in fascia. (1)
fig.9
Mount guide
Fan
vane with
back draught
shutter at the
end of the
duct or just
omit it.
3
2
2
2
Snap in fascia
Guide vane with
back draught
shutter