Gamry Instruments IMX8 Посібник із швидкого старту - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мультиплексор Gamry Instruments IMX8. Gamry Instruments IMX8 4 сторінки.

Hardware Installation and Con�guration

Install your Gamry Instruments potentiostat

Install your Gamry Instruments potentiostat and calibrate the instrument. Please refer to the potentiostat

Operator's Manual for detailed information. The latest version of the manual can be downloaded on the

Gamry Instruments website at https://www.gamry.com/support/documentation-downloads/.

Install the IMX8 Multiplexer cell cables

Each cell to be tested in an experiment requires a cell cable.

The IMX8 comes with eight 1.5 m long cell cables (985-00038).

Connect the 9-pin D-sub connector of the cell cables to the

mating cell cable connectors numbered from1 to 8 on the front

panel of the IMX8 and hand-tighten the jackscrews.

The other cable end has Gamry's standard banana plug/alligator

clip termination to connect to a cell.

Connect your IMX8 to a Gamry potentiostat

When using either a Reference 600+/620 or Interface 1000/1010

potentiostat, a standard 1.5 m long interface cable (985-00080) is

required to couple the potentiostat to your IMX8.

Connect the male 9-pin D-sub connector to the mating Pstat

connector on the front of the IMX8. The male 25-pin D-sub

connector plugs into the mating Cell Cable connecotor of your

potentiostat.

For Reference 3000 potentiostats, an additional Y-cable

(985-00108) is required. Connect the double-end of the Y-cable

to the mating Counter/Working and Sense Inputs on the front

of the Reference 3000.

The standard interface cable (985-00080) is then connected to

the Y-cable's single-end. Connect the male 9-pin D-sub

connector of the interface cable to the mating Pstat connector

on the front of the IMX8.